Difference between revisions of "Programming FTDI devices"
| Line 15: | Line 15: | ||
Number Of Blank Devices = 0 | Number Of Blank Devices = 0 | ||
Number Of Programmed Devices = 1 | Number Of Programmed Devices = 1 | ||
| + | |||
| + | Change: | ||
| + | * Device Type to FT232R | ||
| + | * USB VID/PID to Own VID & PID | ||
| + | * Vendor ID to A600 | ||
| + | * Product ID by table bellow | ||
| + | * Manufacturer to OK1ZIA | ||
| + | * Product Description by table bellow | ||
{| border="1" cellpadding="3" cellspacing="0" | {| border="1" cellpadding="3" cellspacing="0" | ||
| Line 22: | Line 30: | ||
|- | |- | ||
| Davac4 | | Davac4 | ||
| − | | | + | | E110 |
| Davac 4.x | | Davac 4.x | ||
|- | |- | ||
| Rotar4 | | Rotar4 | ||
| − | | | + | | E112 |
| Antenna rotator 4.x | | Antenna rotator 4.x | ||
|- | |- | ||
| USBIO | | USBIO | ||
| − | | | + | | E113 |
| USB GPIOs | | USB GPIOs | ||
|- | |- | ||
| HDKEYB | | HDKEYB | ||
| − | | | + | | E114 |
| HD44780 + Keyboard | | HD44780 + Keyboard | ||
|} | |} | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
Verify entered data, press Ctrl+V and save configuration to file. Pres Ctrl+P to programm. | Verify entered data, press Ctrl+V and save configuration to file. Pres Ctrl+P to programm. | ||
Revision as of 08:42, 4 April 2012
This page describes how to programm the FT232R chip for use in:
You need File:MProg3.5.zip (obsoleted by FT_Prog but always work.
Run MProg
MProg initial state
Disconnect all possible USB devices (can contain FTDI chip also). Connect your device with FT232R. Press Ctrl+N to create new programming template. Press Ctrl+C to scan. MProg responds in bottom box:
Number Of Blank Devices = 0 Number Of Programmed Devices = 1
Change:
- Device Type to FT232R
- USB VID/PID to Own VID & PID
- Vendor ID to A600
- Product ID by table bellow
- Manufacturer to OK1ZIA
- Product Description by table bellow
| Device | Product ID | Product description |
| Davac4 | E110 | Davac 4.x |
| Rotar4 | E112 | Antenna rotator 4.x |
| USBIO | E113 | USB GPIOs |
| HDKEYB | E114 | HD44780 + Keyboard |
Verify entered data, press Ctrl+V and save configuration to file. Pres Ctrl+P to programm.
In bottom box result appears:
Programmed Serial Number : FTVCZQUP
MProg device programmed
Replug the device. Run Control Panel and you'll see new device:
Control panel with new device
