Difference between revisions of "Programming FTDI devices"

From Tučňák Wiki
Jump to: navigation, search
Line 44: Line 44:
 
* Manufacturer to OK1ZIA
 
* Manufacturer to OK1ZIA
 
* Product Description by table above
 
* Product Description by table above
 +
 +
Verify entered data, press Ctrl+V and save configuration to file. Pres Ctrl+P to programm.
 +
 +
In bottom box result appears:
 +
 +
Programmed Serial Number : FTVCZQUP
 +
 +
[[Image:MProgDone.png|none|frame|MProg device programmed]]
 +
 +
Replug the device. Run Control Panel and you'll see new device:
 +
 +
[[Image:MProgControlPanel.png|none|frame|Control panel with new device]]

Revision as of 14:47, 3 April 2012

This page describes how to programm the FT232R chip for use in:

You need File:MProg3.5.zip (obsoleted by FT_Prog but always work.

Run MProg

MProg initial state

Disconnect all possible USB devices (can contain FTDI chip also). Connect your device with FT232R. Press Ctrl+N to create new programming template. Press Ctrl+C to scan. MProg responds in bottom box:

Number Of Blank Devices = 0
Number Of Programmed Devices = 1
Device Product ID Product description
Davac4 A110 Davac 4.x
Rotar4 A112 Antenna rotator 4.x
USBIO A113 USB GPIOs
HDKEYB A114 HD44780 + Keyboard

In Device Type combo choose FT232R. Change:

  • USB VID/PID to Own VID & PID
  • Vendor ID to A600
  • Product ID by table above
  • Manufacturer to OK1ZIA
  • Product Description by table above

Verify entered data, press Ctrl+V and save configuration to file. Pres Ctrl+P to programm.

In bottom box result appears:

Programmed Serial Number : FTVCZQUP
MProg device programmed

Replug the device. Run Control Panel and you'll see new device:

Control panel with new device